Clint, are you not receiving mail. Have you got your sp*m filters turned up too high? I answered this a week ago. This seems to be the second time this has happened. And I sent you some mail off list that you never responded to. What's going on?
You don't have those options if you installed IAA. DMA is on by default and you can check the status in the IAA program. I haven't ever found any options for it at all. Ben Moore -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Tuesday, December 16, 2003 6:00 AM To: [EMAIL PROTECTED] Subject: PCWorks: No DMA mode choices for PRI & SEC controller in XP Pro Can someone tell me please where you enable/disable DMA for the PRI and SEC controllers in XP Pro? I don't have it where it should be in the Device Manager. I was told there is an "advanced" tab for these settings but I don't have it. I THINK I remember seeing them before the mobo drivers or the IAA was installed. If that's the case, does installing "fast" mobo drivers or the IAA remove the "advanced" tab for the controllers in the Device Manager? Maybe the IAA makes DMA enabled all the time? (IAA = Intel Application Accelerator). Mobo is a P4B533, 845PE chipset and in the DM for the IDE PRI & SEC controllers it has "Intel 82801DB Ultra ATA controller" which uses the IAA. That for sure supports DMA. ? Then under the "Intel 82801DB Ultra ATA controller" it as the PRI and SEC IDE entries. No "advanced" tabs for ANY of them. Thanks, -Clint ============= PCWorks Mailing List ================= Don't see your post? Check our posting guidelines & make sure you've followed proper posting procedures, http://pcworkers.com/rules.htm Contact list owner <[EMAIL PROTECTED]> Unsubscribing and other changes: http://pcworkers.com =====================================================
