HTH
Happy holidays,
Peter Kaulback
In the hour of 09:31 AM 12/16/2003, [EMAIL PROTECTED] spoke this:
Yeah I know Peter. I thought I made that clear, sorry if I didn't. Please read again. Mine is NOT THERE, I don't have the "advanced" tabs, and my question was, why? Does the IAA remove that tab, or advanced Intel mobo drivers remove it? Thanks, -Clint
Happy Holidays to all & God Bless Clint Hamilton, Owner http://OrpheusComputing.com )
----- Original Message ----- From: "Peter Kaulback" <[EMAIL PROTECTED]>
Clint go into System in Control Panel then Hardware, Device Manager, IDE ATA/ATAPI controllers. Then under Advanced Properties for the Primary and Secondary IDE Channel Properties you can select "DMA if available" or "PIO only".
Peter Kaulback
In the hour of 06:00 AM 12/16/2003, [EMAIL PROTECTED] spoke this:
>Can someone tell me please where you enable/disable DMA for the >PRI and SEC controllers in XP Pro? I don't have it where it >should be in the Device Manager. I was told there is an >"advanced" tab for these settings but I don't have it. I THINK >I remember seeing them before the mobo drivers or the IAA was >installed. If that's the case, does installing "fast" mobo >drivers or the IAA remove the "advanced" tab for the >controllers in the Device Manager? Maybe the IAA makes DMA >enabled all the time? (IAA = Intel Application Accelerator). >Mobo is a P4B533, 845PE chipset and in the DM for the IDE PRI & >SEC controllers it has "Intel 82801DB Ultra ATA controller" >which uses the IAA. That for sure supports DMA. ? Then under >the "Intel 82801DB Ultra ATA controller" it as the PRI and SEC >IDE entries. No "advanced" tabs for ANY of them. >Thanks, >-Clint
============= PCWorks Mailing List ================= Don't see your post? Check our posting guidelines & make sure you've followed proper posting procedures, http://pcworkers.com/rules.htm Contact list owner <[EMAIL PROTECTED]> Unsubscribing and other changes: http://pcworkers.com =====================================================
