On 30/10/12 06:12, Johanna Nowak wrote:
Jörn,
this is a quick shoot from the hips, perhaps it can help:
* Jörn Nettingsmeier<[email protected]> [2012-10-29 20:38]:
is there a way to prevent pd from doing this? particularly in the
alsa midi case, it's a really blatant misfeature, because in the
presence of a software midi thru port, it will immediately create a
parameter loop which will make any connected midi controller go wild
and burn its motors.
If this is the case for the BCF2000 try using its "U-3" or "S-3" mode,
where it will not echo the received midi data to its outputs.
The BCF2000 and the Pd sliders work very well together with feedback - not sure
exactly which side does the work to allow the loopback to work well, but it
does, it is possible to use those loops to give manual control from the BCF2000
at the same time as Pd sliders and calculated values are being used.
Simon
_______________________________________________
[email protected] mailing list
UNSUBSCRIBE and account-management ->
http://lists.puredata.info/listinfo/pd-list
