Sven, Thanks for the hints. I think finding pliers to fit the nuts well will be tricky...
Dan Quoting "keller.schaefer" <[EMAIL PROTECTED]>: > Dan, > > this is from looking at (and remembering the repair of) a Super A but I > doubt the program A is different: > > On the left side you also need to remove the rewind knob (open the camera, > feed a srewdriver into the spindle fork and hold, then turn the knob > counter-clockwise) and remove the slotted nut around the spindle (use a well > fitting tool, e.g. filed-to-size pliers). IIRC you do not need to remove the > two small screws, these hold the compensation dial together so you better > put them back in...) > On the right side you need to take off the wind lever and what is below (I > don't remember anything being left hand thread on this camera), again > probably a slotted nut. > If I am not wrong the on-off-mode switch can remain on the top plate (if you > have to take it off there also is a slotted nut around the shutter release) > but remember to put the cover back on in the B setting. > > Hope this helps... > > Sven
