Sorry to hear about your PC trouble, Don. I hope it hasn't done any permanent damage to your system. Something similar happened when I tried it on a 2001 vintage Fujitsu-Siemens PC in the office, after I had upgraded the ActiveX. Mike Without knowing the exact hardware involved, I suspect that an older type 3D support in the graphics card is the culprit. The office PC has behaved normally afterwards.
It sucks that the software need so sophisticated hardware to run properly. :-( Glad to hear you liked the show, though...:-) Best, Jostein ----- Original Message ----- From: "Don Williams" <[EMAIL PROTECTED]> I ran it and was impressed. Then my screen went blank and the disks drives were accessed continuously for about fifteen minutes. I could do nothing. The only way I could get the PC going again was to switch it off at the mains. Reset, Cntrl+Alt+Del and other approaches didn't work. It /seems/ okay now, but I'm not sure. Check Disk ran for about fifteen minutes on several drives after I switched it back on. I'm going to restore to yesterday in any case. Your file has been erased. Don -- PDML Pentax-Discuss Mail List [email protected] http://pdml.net/mailman/listinfo/pdml_pdml.net
