Perhaps it's a Photoshop problem. I already gave up. I cut it up into four pieces and printed them as 10.6 by 18 prints. I'm matting them and framing them individually. The cost of the frame and the mat for a 10.6 by 72 would probably have been prohibitive anyway. Paul On Dec 3, 2006, at 6:21 PM, Mark Cassino wrote:
> Paul - > > I missed the first part of this thread. A while back I did a large > pano > on 10 inch wide Epson Premium Lustre paper. the photo was something > like > 4 feet long. > > For the life of me, I could not get Photoshop to print the damn > thing. I > wound up printing it in Corel Photopaint. I assume you are using > Photoshop - perhaps it is the culprit. > > _ MCC > > David Mann wrote: >> On Dec 3, 2006, at 2:28 AM, Paul Stenquist wrote: >> >>> Thanks David, >>> That solves one of my problems. I set up the roll paper printer. I'm >>> all set to go now, but I can't get the printer to stop flashing the >>> paper feed light. It thinks there's no paper in it. When I push the >>> paper feed button, it tries to run the whole roll through. I've >>> tried >>> releasing the bale and then setting it back to the first position. >>> That >>> didn't work. I tried pushing the roll paper button on the far >>> left of >>> the three buttons. That didn't work. Any thoughts? >> >> Are you sure you've fed the paper in the correct slot? The roll- >> paper slot is behind the cut-sheet one. I know that sounds obvious >> but it's all I can think of at the moment. >> >> BTW the auto-cutter accessory is quite good if you expect to do a lot >> of roll printing. >> >> - Dave >> >> > > > -- > - - - - - - - - - - - - - - - - - - - - > Mark Cassino Photography > Kalamazoo > www.markcassino.com > - - - - - - - - - - - - - - - - - - - - > > -- > PDML Pentax-Discuss Mail List > [email protected] > http://pdml.net/mailman/listinfo/pdml_pdml.net -- PDML Pentax-Discuss Mail List [email protected] http://pdml.net/mailman/listinfo/pdml_pdml.net
