Bruce Walker wrote:
paul stenquist wrote:
I've done it. Don't have time to check now, but I know trailing
curtain is set with the lower power switch. I think it's the second
click to the right of off. I've used it on the K20D and it works.
Paul
Well on the AF-540FGZ it's configured on the switch labeled "Sync.",
immediately to the left of the main power switch, and it's the second
click to the right of leading curtain sync (wireless mode is set on the
main power switch, the intermediate click between Off and On). I have
verified that that works fine when the 540 is mounted on-camera. And
TCS works using the built-in flash too.
But if I move the flash off-camera and try to go wireless, phxxxt! No
trailing curtain. I've tried it with both the built-in flash as
controller, and another 540FGZ as controller.
The K20D manual even states on page 148 (bottom) that if TCS is set on
the remote flash, the internal flash will adopt that mode too. But not
for me. Very annoying.
I'm beginning to wonder if the recent firmware upgrade broke wireless
trailing curtain. Sadly I can't test that, and I never tried WTCS
before the upgrade.
-bmw
silly question, but did you make sure the flash and camera were on the
same channel?
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
