The volume command (vol [drive:]) will display the volume name. Use the
label command to set the volume name.
http://tinyurl.com/elaet
-p
On 11/1/2013 10:47 PM, Godfrey DiGiorgi wrote:
http://pcsupport.about.com/od/termsv/g/volume-label.htm
I'm not a Windows user, but that page seems to give the basic info required.
A volume label is a higher level file system construct than a drive letter and
persists even if the drive letter changes. Once you set volume labels for your
system, start LR. It will pick them up and display them in the Folders panel.
Once a volume label is in use, LR uses that instead of a drive letter because
file system calls to a volume label are translated by the OS to the underlying
current hardware letter identifier.
Godfrey
On Nov 1, 2013, at 8:17 PM, Igor Roshchin <[email protected]> wrote:
Godfrey,
How would I do that on Windows?
Once I import the photos from the HDD, LR (at least up to ver. 3.4)
sets that the photos are on a particular HDD, with a specific drive letter.
I was not able to find how I can disentangle from that.
Igor
Fri Nov 1 15:44:20 EDT 2013
Godfrey DiGiorgi wrote:
If you set a drive label (volume name for OS X users, but volume
names/labels are only optional on Windows), Lr will use and prefer that,
all the confusion of changing drive letters will disappear.
Godfrey
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
--
Being old doesn't seem so old now that I'm old.
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
