There's always another bug.
On 3/8/2014 10:21 AM, Darren Addy wrote:
What firmware were you using?
A dpreview poster claims to have found a bug in 1.02 for the K-3 (a
problem that cropped up only after he upgraded). Not the SAME problem
as Rob's, but illustrates the point.
It is possible that there are other bugs that need to be reported and
stamped out for future firmware releases. Rob's problem may be one of
them.
On Fri, Mar 7, 2014 at 6:06 PM, John <johnsess...@yahoo.com> wrote:
I wouldn't expect it to switch back immediately when card #1 was
replaced, but if you replace #1 with an empty card, will it switch back
to card #1 when card #2 gets full?
On 3/7/2014 11:23 AM, Bob Sullivan wrote:
So I'm trying this again from gmail, hopefully it will be in Plain text
mode.
I experienced some unexpected card slot behavior in San Diego.
I filled the 1st card and automatically moved to #2.
Then I took #1 card out and downloaded it to the laptop.
Card #2 took over, but when I replaced card #1, it stayed on #2.
I had to fiddle with the menu settings to get it back to #1.
I suspect the software transitions from #1 to #2, but has trouble
going back to #1 automagically.
Regards, Bob S.
--
PDML Pentax-Discuss Mail List
PDML@pdml.net
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and
follow the directions.
--
A newspaper is a device for making the ignorant more ignorant, and the crazy,
crazier.
- H.L.Mencken
--
PDML Pentax-Discuss Mail List
PDML@pdml.net
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
