I have a little toy helicopter with camera that came to an unfortunate
end by crashing into a wall at full throttle. As part of the repair, I
need to unsolder the wires to the motors and then solder them back on
after mounting them in the new airframe.
I've never actually done this before. I have a variable temperature
soldering iron with a very fine tip,
see it here:
http://www.amazon.ca/gp/product/B00C04FADG/ref=shptrk_scth#productDetails
Any hints, such as how to do it, do I add solder? Do I tin the wire? How
hot, etc.
thanks
bill
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
