John wrote:
On 2/8/2017 10:21 PM, Larry Colen wrote:
I see to recall that green mode shoots only jpeg. If I wanted my
housemate to be able to pick up my camera and get photos of the flood
waters tomorrow, I could say Tav, f/2.8-4 1/60-1/100. Will P mode
automatically pick a good ISO?
I don't see anything in the manual that says "Green mode" shoots only
jpeg. If it's in there, I didn't find it.
I am sure that I remember reading that, and trying it out. However that
must have been on an older model because I just tried it and it seems to
be in raw on both the K-3 and K-1.
You could download the Operating Manual as a PDF & use it to guide you
while you tell your housemate how to set the various controls instead of
relying on us for second hand misinformation.
As we can see from the above, your second hand disinformation is more
accurate than my first hand disinformation.
http://www.ricoh-imaging.co.jp/english/support/man-pdf/k-3.pdf
You are making the assumption that I hadn't tried to RTFM. In my
experience the manual aspires to uselessness. The index points to
setting the auto iso limits, but not turning them on or off. I tried
searching the manual, several times, and wasn't able to find it, until I
was able to find it and then I was. On some of those searches, I will
admit that I couldn't see where auto iso was highlighted on the page.
I was hoping that someone else had gone through this and could just say
"simultaneously press the iso and the green buttons to put it into auto
iso, but that only works in these modes....", which would have saved me
about 45 minutes of trying to find the information.
--
Larry Colen [email protected] (postbox on min4est) http://red4est.com/lrc
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
