In DXP go to Auto-route - setup, and check 'Lock all pre-routes'. That should do the trick. If you use 'Undo' to remove the auto routed tracks I have found that some pre-placed vias to the power planes are also removed.
Regards, Dave Courtney -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of ? Sent: 28 October 2004 06:50 To: Protel EDA Discussion List Subject: [PEDA] not to change the result of manul routing Hello everyone After I routed some important tracks I start auto route. But auto route always cleaned some tracks I routed manually. I think there may be some options set to disable this but I cannot find. Could you please tell me? Xiangchen ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[EMAIL PROTECTED] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[EMAIL PROTECTED] ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[EMAIL PROTECTED] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[EMAIL PROTECTED]
