In DXP, go to Design Rules, Routing Layers and assign a default direction ( horizontal, vertical etc.) to each layer you want to route. I don't recall the exact command for 99SE, but it will be something similar.
Bob -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of ? Sent: Friday, October 29, 2004 1:52 AM To: Protel EDA Discussion List Subject: [PEDA] no track is routed in MidLayer1 and MidLayer2 Hello everyone, May be a fool question. When I do auto route for a 6-layered board, no track is routed in MidLayer1 and MidLayer2. Could you please tell me what setup must be done. Thanks very much. Xiangchen ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[EMAIL PROTECTED] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[EMAIL PROTECTED] ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[EMAIL PROTECTED] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[EMAIL PROTECTED]
