hmm, I think when you are asking for outline you wanted to route the copper around the tracks, not route the board itself. CAMtastic can create an outline but, the PAD outlines are drawn over the track outlines, so there will be a break in the copper. So, AFAIK Protel/DXP can't do what you are after, you may find some software on the internet that can create this from the gerber files.
Darren > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Darren > > > John, > > CAMtastic can produce routing files, they are much > the same as gerber files, so a mechanical gerber file > would have the details required in it. > > Darren Moore > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > > > > > Hi All, > > > > I found an interesting site: > > > > http://cryolite.ath.cx/perl/skin/pcb-router > > > > The author uses Eagle which can apparently make an outline that > > he then uses to run his little mill. Is it possible to get > > Protel 99SE to do that sort of thing? > > > > Thanks, > > > > John Dammeyer ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[EMAIL PROTECTED] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
