ok thanks!
would you be so kind as to further explain the purpose and use of this field ?
Dennis Saputelli
_______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com
PCB Designs wrote:
Hi Dennis,
i have imported a V7 Orcad Schematic (had to save back from v10 which wouldn't come in) it didn't make too much of a mess (it was one big sheet) but all the parts have the 'SHEET PATH' field stuffed with various numbers like _53, _123 i suspect they are unique numbers what is this SHEET PATH thing? i have never understood or used it i am tempted to globally blank them all out or make them all * should i do that or just ignore them ?
Yes, you should make them all * , if not your netlist will not show any parts that have a number on the SHEET PATH field.
BRgds, Paulo Egon
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages: mailto:[EMAIL PROTECTED]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[EMAIL PROTECTED]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
