Darren Thanks
The issue was actually overlapped pads. Thanks to Andrew at Premier for finding that one. I had a stuffing option on the board, one of two resistors could be fitted but as it was one input and 2 source selection I overlapped the resistor pads sharing the same net so that it was possible only to ever place 1 part at that location to avoid the obvious mistake waiting to happen at assembly.... John > -----Original Message----- > From: Darren [mailto:[EMAIL PROTECTED] > Sent: 14 December 2004 12:09 > To: 'Protel EDA Discussion List' > Subject: RE: [PEDA] SI Tool will not run > > > Hi John, > > You might check that none of the ini type files have exceeded > 64K, I think the one that stores the last open files info > once over 64k can cause problems. One of the RCS files I think. > > Darren Moore > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf Of John A. > > Ross [Design] > > > > Hi > > > > For some reason I got gremlins in my P99SE installation today. > > > > If I try and run Tools . Signal integrity the dialogue box comes up > > with greyed out buttons, hangs around a bit then closes by > itself. I > > cannot get it to run. I had something in my notes before about > > regional settings but they seem OK. > > > > For now I cannot see that I did anything to upset it, I tried a > > re-installation after a logical explanation failed but got > exactly the > > same results. Very strange. > > > > If anyone has had a similar experience and found a solution > please let > > me know. > > > > Thanks > > > > John > > > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[EMAIL PROTECTED] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[EMAIL PROTECTED] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
