Hi Gang,
Does anybody here have any idea why I would be getting the following
error message on several P99SE library parts that I am trying to port from my
P99SE libraries into a DXP integrated library?
All three parts exhibiting the problem are simple logic gates (ie. 4 gates
(parts) of a 2 input NAND). There are the 2 input pins and 1 output pin on each
gate and then on the 4th gate there is the additional VCC and GND pins. The
message I get is:
[Warning] IC_99.LIB Compiler 31-13-000 CMOS 74HTC
MM74HCT00M: Could not find ' '
Every pin has a pin number, none are " " (blank). So I don't understand
what the message is trying to point out. I have seen this same message on some
special parts where there was a pin with a blank pin number, so I have been
trying to find the same in these symbols but a blank pin number just doesn't
exist.
I have many more multi-part logic gates that work just fine, thus far I
cannot determine what is different to make these few fail while the others
integrate just fine.
Any ideas, suggestions? What is the error message trying to point out
that I am missing?
Just plain brain-dead on this one,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
