Rather than use the reports-netlist status you could try and select your coil area and use the report-measure selected objects.
Regards, Casey. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Leo Potjewijd Sent: May 3, 2005 7:36 AM To: [email protected] Subject: [PEDA] negative net length? I just finished a PCB coil and asked the PCB editor of P99SE how long the copper trace actually is (report - netlist status) to get an idea of the DC resistance to see if I need bigger or thicker traces. The reports reads "Length:-85018 mils". That cannot be right, as far as I can remember length should always be a positive number.... Obviously there is some sort of overflow, but how do I find the correct length (assuming that the overflow is no more than one bit)? I can only remember that there was a simple trick, but I cannot remember the trick itself. Any of you remember it enough to put me back on track (no pun intended)? Thanks, Leo ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected] ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
