Harry,
just wondering, did you reply directly to Soren the first time? I saw
him reply to your response and I see your second response below but didn't get
your initial reply. Seems the PEDA server is acting up and missing on the
delivery of some messages.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Harry Selfridge [mailto:[EMAIL PROTECTED]
Sent: May 8, 2005 10:06 AM
To: Protel EDA Discussion List
Subject: Re: [PEDA] PCB: Place from file?
Soren,
I assume you must be using Protel99SE, since DXP2004 has special utilities
for doing multi-channel boards.
I just tried it and it works perfectly using Protel99SE. I saved a PIK
file, moved a component off the board and rotated it, saved my modified
board, then auto positioned using the PIK file I saved earlier. The
component ended up back where it was before I made the changes.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
