Engineers and technicians alike occasionally neglect to place all the final PCB components on their electrical schematics, especially in flexible programs like Protel EDA (can't say with certainty for DXP, but for previous versions) The solution to your problem is self-evident. Put the caps on your schematic and re-run the BOM generator...
regards, aj >-----Original Message----- >From: [EMAIL PROTECTED] >[mailto:[EMAIL PROTECTED] On Behalf Of Zentz, David L >Sent: Friday, May 06, 2005 3:15 PM >To: [email protected] >Subject: [PEDA] Bypass capacitors > >The bypass capacitors for each of the IC's in a project I've >taken over are displayed on the PCB Layout view but not on the >BOM or the schematic. How do I get those components listed on the BOM? > > >____________________________________________________________ >You are subscribed to the PEDA discussion forum > >To Post messages: >mailto:[email protected] > >Unsubscribe and Other Options: >http://techservinc.com/mailman/listinfo/peda_techservinc.com > >Browse or Search Old Archives (2001-2004): >http://www.mail-archive.com/[email protected] > >Browse or Search Current Archives (2004-Current): >http://www.mail-archive.com/[email protected] > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
