I'm definitely checking with my local guys, but our stuff goes overseas and i appreciate getting some general feedback if anyone has that experience.
thanks again Duane Foster > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Brad Velander > Sent: Thursday, January 19, 2006 11:52 AM > To: Protel EDA Discussion List > Subject: Re: [PEDA] 16 layer question > > > Duane, > Best to do a quick check with your fabricator(s). > Anyone here could say yay or nay based upon what their > fabricator can do and then you may end up where your > fabricator says they can't do it that way. > Your fabricator(s) should be your most valuable tool, > your process should use the best available tools. > > Sincerely, > Brad Velander > Senior PCB Designer > Northern Airborne Technology > #14 - 1925 Kirschner Road, > Kelowna, BC, V1Y 4N7. > tel (250) 763-2329 ext. 225 > fax (250) 762-3374 > > > > -----Original Message----- > From: Duane Foster [mailto:[EMAIL PROTECTED] > Sent: Thursday, January 19, 2006 11:24 AM > To: Protel EDA Discussion List > Subject: [PEDA] 16 layer question > > > I'm designing a 16 layer board and would like it to be > 'vanilla' (easy to make - low cost). Is .062" board > thickness pretty standard fare for 16 layer? > > thanks > Duane Foster > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
