Hi Kat, Don't start the track from the centre of the pad, that way you get the list of layers to pick from. After that you'll find you can delete that bit of track and then start from the centre and it will work. Weird...
Dave -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Kathy Quinlan Sent: Monday, 30 January 2006 2:41 a.m. To: Protel EDA Discussion List Subject: [PEDA] ARRRGGGHHHH 99SE SP6 can not manual route NET Hi all, This is my stupid fault but....... I have a over crowded PCB, I have a section (filters) where I have components top and bottom of the PCB, they are identically aligned ie if you look through the board, the other side is shadow of the side viewed from. The problem is that I am getting a net from the other side when I want to route one side, in this case I am trying to route the top, but I am grabbing a bottom net :( I have tried selecting the net, selecting all the components pads on the net, using single layer mode, turning the bottom layer off, all to no avail, I think this is due to the pad centers being 100% in allingment? Any ideas how to do this, or do I need to move all the components off the same centers ??? -- Regards, Kat. --------------------------------------------------------------- K.A.Q. Electronics Website: www.kaqelectronics.dyndns.org IM: Yahoo: PinkyDwaggy MSN: [EMAIL PROTECTED] For Everything Electronics Phone: 0419 923 731 --------------------------------------------------------------- -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.375 / Virus Database: 267.14.23/243 - Release Date: 27/01/2006 ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected] ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
