Hi Guys,
Our other office (the dark-side that uses PADs) was just asking me if I
knew how to get drill drawings out of PADs for either Blind or buried Vias. I
had a look through PADs CAM tool and found the setup for the NC drill pretty
understandable but I couldn't find any manner of getting drill drawings for the
different drill layer pairings. It seemed that for a drill-drawing it was ALL
drills (regardless of layer pairs) or None, no in-between. So how is it
typically done?
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2232 ext. 225
fax (250) 762-3374
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
