Thanks Andrew,
Interesting device. I don't think it could qualify for proper
inspection of BGAs though, it would never spot even the largest voids within a
joint, let alone several rows in.
Or is that a pie in the sky target that people normally don't even
inspect to unless you are the largest of EMS providers with the full X-ray
inspection capability? I am well up on my reading but don't have the practical
experience regarding the inspection of BGAs.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2232 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Riley, Andrew [mailto:[EMAIL PROTECTED]
Sent: Friday, March 23, 2007 8:38 AM
To: Protel EDA Discussion List
Subject: Re: [PEDA] Hot Air reflow stations.
Brad,
Regarding BGA inspection;
Our board house uses
http://www.olympusindustrial.com/index.cfm/page/products.index.cfm/cid/1
297/navid/284/parentid/2
Among other things.
Cheers!
Drew
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
