You can get this error if the PBL that contains the object is read only.
Are you using source control? When you say disconnection, from what? Is it
possible that whatever you are disconnection from has a lock on that PBL? I
would also check the pfe_main.pbl's status as well.
D
----- Original Message -----
From: FRAIKIN Francis <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Wednesday, December 15, 1999 11:13 AM
Subject: PFCSIG Save object failed
> After modification of an event of an object inherited from u_dw,
> I receive the message "Save object failed"
> After reboot of PB same error
> But after reboot or deconnection I can save the object
> after modification of the same event.
> After a test of my modification and some debug, the same
> problem is comming again.
>
> Configuration : PB 6.5 on NT4 WKS with SP6
>
> _______________________________________________________
> Francis FRAIKIN
> MET - IG42 Tel : +32-4-2545816
> Rue C�te d'Or 253 Fax : +32-4-2530405
> B-4000 LIEGE E-mail : [EMAIL PROTECTED]
> BELGIUM
>
>
> > [EMAIL PROTECTED] HOSTED BY IIGG, INC. FOR HELP WITH LIST SERVE COMMANDS,
ADDRESS
> > A MESSAGE TO [EMAIL PROTECTED] WITH THE FOLLOWING MESSAGE: help
pfcsig
> > SEND ALL OTHER INQUIRES TO [EMAIL PROTECTED]
>
> [EMAIL PROTECTED] HOSTED BY IIGG, INC. FOR HELP WITH LIST SERVE COMMANDS, ADDRESS
> A MESSAGE TO [EMAIL PROTECTED] WITH THE FOLLOWING MESSAGE: help pfcsig
> SEND ALL OTHER INQUIRES TO [EMAIL PROTECTED]
