Also try optimizing the pbl.
Russ
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]
Sent: Wednesday, December 15, 1999 3:08 PM
To: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: RE: PFCSIG Save object failed
Hi,
Most probable cause is not enough of disk space available.
Look to see if
your free disk space is too small. Keep in mind that even
if some fee space
is available, at least 100MB (for temporary swap files) are
required to run
the PB IDE.
Two other causes are possible, depending on your
circumstances, the pbl
could be being temporarily locked or made "read-only" by
some other process
(such as another developer).
Lester LaForce
Consultant, COMSYS
U.S. Army, Personnel Information Systems Directorate
Washington DC area
-----Original Message-----
From: FRAIKIN Francis [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, December 15, 1999 11:14 AM
To: [EMAIL PROTECTED]
Subject: PFCSIG Save object failed
After modification of an event of an object inherited from
u_dw,
I receive the message "Save object failed"
After reboot of PB same error
But after reboot or deconnection I can save the object
after modification of the same event.
After a test of my modification and some debug, the same
problem is comming again.
Configuration : PB 6.5 on NT4 WKS with SP6
_______________________________________________________
Francis FRAIKIN
MET - IG42 Tel : +32-4-2545816
Rue C�te d'Or 253 Fax : +32-4-2530405
B-4000 LIEGE E-mail : [EMAIL PROTECTED]
BELGIUM
> [EMAIL PROTECTED] HOSTED BY IIGG, INC. FOR HELP WITH LIST
SERVE COMMANDS,
ADDRESS
> A MESSAGE TO [EMAIL PROTECTED] WITH THE FOLLOWING
MESSAGE: help pfcsig
> SEND ALL OTHER INQUIRES TO [EMAIL PROTECTED]
> [EMAIL PROTECTED] HOSTED BY IIGG, INC. FOR HELP WITH LIST
SERVE COMMANDS, ADDRESS
> A MESSAGE TO [EMAIL PROTECTED] WITH THE FOLLOWING
MESSAGE: help pfcsig
> SEND ALL OTHER INQUIRES TO [EMAIL PROTECTED]
> [EMAIL PROTECTED] HOSTED BY IIGG, INC. FOR HELP WITH LIST SERVE COMMANDS, ADDRESS
> A MESSAGE TO [EMAIL PROTECTED] WITH THE FOLLOWING MESSAGE: help pfcsig
> SEND ALL OTHER INQUIRES TO [EMAIL PROTECTED]
