Sure: http://gemstonesoup.wordpress.com/2011/01/17/metacello-1-0-beta-28-unearthed/
Be sure to look at the section of development cycle ... and tools support, too... Dale On Feb 4, 2011, at 6:37 AM, Guillermo Polito wrote: Dale, Is there a place where I can read how to configure the symbolic versions? Thx! Guille :) On Fri, Feb 4, 2011 at 11:29 AM, Dale Henrichs <[email protected]<mailto:[email protected]>> wrote: ConfigurationOfPharo should have a #stable symbolic version defined that specifies the version that should be used in 1.2, 1.1, and 1.0 ... then one just loads the #stable version: (ConfigurationOfPharo project version: #stable) load and you'll get the right version loaded for the platform version ... even though the version is under development I think it is valid to specify a #stable symbolic version for Pharo1.2, just so folks don't have to ask this question over and over again ... Don't let the name 'stable' scare you ... The intent is that the #stable symbolic version specifies the version that should be loaded .... the developer decides which versions are #stable for each platform version and when a new version becomes "the version to use" the developer updates the specification. The users of a configuration shouldn't have to think ... remember in the past the recommended pattern was: ConfigurationOfPharo project latestVersion load and that worked fine until Pharo1.1 and Pharo1.2 were introduced. The expression: (ConfigurationOfPharo project version: #stable) load is intended to replace the use of #latestVersion because it makes it possible to explicitly specify the "latest version" on a platform by platform and platform version basis... Sorry if I appear to be ranting ... I'm just trying to get the message out:) Dale On Feb 4, 2011, at 6:01 AM, Guillermo Polito wrote: I'm Using '1.2-beta2'. Should we remove invalid and unused versions? I'll add a few comments at lunch time ;) On Fri, Feb 4, 2011 at 10:53 AM, Germán Arduino <[email protected]<mailto:[email protected]><mailto:[email protected]<mailto:[email protected]>>> wrote: I tried the 2 latest Beta and fail, also the 1.1 version fail. Which ConfigurationOfPharo I should use with Pharo 1.2 ? Cheers.
