Steve, I would like 2 of the 1-56 taps. What size drill should be used in case you have to drill out a broken screw? Harvey Kravitz
________________________________ From: Bob Maffit <maff...@bresnan.net> To: 'Antique Phonograph List' <phono-l@oldcrank.org> Sent: Friday, February 17, 2012 2:25 PM Subject: Re: [Phono-L] Victor reproducer question Steve: I sure would like 2 of the 1-56. In the event you have them for the other Victor reproducers,( if different than 1-56, 2 of each as well. . Please let me know Bob -----Original Message----- From: phono-l-boun...@oldcrank.org [mailto:phono-l-boun...@oldcrank.org] On Behalf Of Steven Medved Sent: Friday, February 17, 2012 6:17 AM To: phono-l@oldcrank.org Subject: Re: [Phono-L] Victor reproducer question 1-56 for the Exhibition. I am almost positive 1-72 on the 2, 4 and 5 Victor reproducers, I will double check unless someone else confirms. Do you need a 1-56 tap? I have some NOS ones. If a number of people want them I can put an order together as the cost will be under $2.50 for each one if they are still available. I like two, one I keep the point on and one I grind flat. I believe they are from the 1950's as they are deeply stamped. Steve > From: maff...@bresnan.net > To: phono-l@oldcrank.org > Date: Thu, 16 Feb 2012 20:36:35 -0700 > Subject: [Phono-L] Victor reproducer question > > Phono listers: > > > > What are the thread sizes for the thumb screw on: Victor: > > exhibition, n. 2, and 4a reproducers? > > > > again thanks > > > > Bob > > _______________________________________________ > Phono-L mailing list > http://phono-l.org _______________________________________________ Phono-L mailing list http://phono-l.org _______________________________________________ Phono-L mailing list http://phono-l.org _______________________________________________ Phono-L mailing list http://phono-l.org