I knew you'd set me straight, Steve.   Thanks.

 

Ron

 

From: SN Medved via Phono-L [mailto:phono-l@oldcrank.org] 
Sent: Monday, February 01, 2016 10:22 PM
To: Antique Phonograph List
Cc: SN Medved
Subject: Re: [Phono-L] Edison Triumph A 2/4 minute conversion kit?

 

Hello Ron,

 

Edison links vary from .0175 to .0192 in diameter.  I use .020 annealed 
stainless steel wire to make links for them all except for the O and M which I 
use .018 annealed steel wire.  The O link is longer than the M link.  

 

Staple wire is too small in my opinion as it is .0175 on one side and .0186 on 
the other as it is not round.  The length is about right for the bent weight N 
but too long for the C or H.  

 

Steve

 

  _____  

From: Ron L'Herault via Phono-L <phono-l@oldcrank.org>
Sent: Monday, February 1, 2016 10:10 PM
To: 'Antique Phonograph List'
Cc: Ron L'Herault
Subject: Re: [Phono-L] Edison Triumph A 2/4 minute conversion kit? 

 

I've been told that an ordinary office style staple is the right length and 
diameter for this link wire.  How far from the truth is that?

 

Ron L

 

From: amberola75--- via Phono-L [mailto:phono-l@oldcrank.org] 
Sent: Monday, February 01, 2016 9:08 AM
To: phono-l@oldcrank.org
Cc: amberol...@aol.com
Subject: [Phono-L] Edison Triumph A 2/4 minute conversion kit?

 

Hello Everyone, 

 

I was wondering if there are any printed or "known" specifications for the 
fabrication dimensions of all of the different Edison reproducer "S" or "C" 
hooks that connect the diaphragm to the stylus?  Like actual center to center 
distance, radius on the ends, wire diameter, etc.  Any info would be helpful as 
I would like to machine a few small fixtures to make them instead of trial and 
error. 

 

Thanks,

Jim Reisenweber

Image removed by sender.

Image removed by sender.

Image removed by sender.


Reply via email to