I'm on a redhat 7.1 box on a pentium 3 pc. I set up networking via netcfg.
Here are the settings (names have been modified):
Names
Hostname localhost.localdomain
Hosts
IP Name Nickname
-----------------------------------------------------
127.0.0.1 localhost.localdomain localhost
199.33.57.1 windowshost
198.77.110.8 internet.com ghc000
Interface
interface IP Proto
----------------------------------------------------------
lo 127.0.0.1 None
eth0 199.33.57.3 None
Routing
Default Gateway 199.33.57.7
default gateway device eth0
Again, I appreciate your help.
best,
daniel
-----Original Message-----
From: mike cullerton [mailto:[EMAIL PROTECTED]]
Sent: Monday, July 02, 2001 3:06 PM
To: 'PHP List'
Subject: Re: [PHP] newbie has include path error & new problem
on 7/2/01 3:59 PM, Daniel Goldin (E-mail) at [EMAIL PROTECTED] wrote:
> Yes, I could load a page from localhost until I set up networking.
>
> No, I cannot load a page from 127.0.0.1. Tried that.
>
> Embarrassed to ask. What is a routing table and how do I find it?
no need to be embarrased for not knowing what a routing table is, most
people wouldn't. a routing table is used by a networked computer to
determine how to reach remote hosts. it tells the machine what interface to
use for a particular host and physical layer address to send to.
what kind of a machine are you on?
what steps (specifically) did you take to 'set up networking'?
-- mike cullerton
--
PHP General Mailing List (http://www.php.net/)
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
To contact the list administrators, e-mail: [EMAIL PROTECTED]
--
PHP General Mailing List (http://www.php.net/)
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
To contact the list administrators, e-mail: [EMAIL PROTECTED]
