Well, thanks for all the pointers to ColdSync (which looks like an
outstanding system), and to the FreeBSD USB support stuff.
However, it's installed, runs, and all that. When I have usbd runing, and
the Visor is recognized, when I try to sync...
ugen0: Handspring Inc Handspring Visor, rev 1.00/1.00, addr 2
Fatal trap 12: page fault while in kernel mode
fault virtual address = 0x3
fault code = supervisor read, page not present
instruction pointer = 0x8:0xc02c721f
stack pointer = 0x10:0xcd0aed28
frame pointer = 0x10:0xcd0aed38
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 362 (coldsync)
interrupt mask = bio
trap number = 12
panic: page fault
BOOM! 8)
Consistently - after i do 'coldsync -p /dev/ugen0 -b .'
I may sign on the freebsd-usb list to see if anyone else has had this
problem, but looks like I may have to dig up a serial Visor cradle. :-/
-d.
______________________________________________________
-------------------< Biz: stonekeep.com | Hom: homeport.org | Mob: KB1FWR >
Dave Belfer-Shevett >-------------------^-------------------^------------<
[EMAIL PROTECTED] / Keep looking around. There's always something you've \
------------------< missed. (from Rules of the Air) |
\______________________________________________________/
_______________________________________________
Pilot-unix mailing list
[EMAIL PROTECTED]
http://hcirisc.cs.binghamton.edu/mailman/listinfo/pilot-unix
