[Network configuration] --- https://www.pld-linux.org/docs/man/installing_pld_linux_based_on_rescue_cd?rev=1548094749 +++ https://www.pld-linux.org/docs/man/installing_pld_linux_based_on_rescue_cd?rev=1548095458 @@ -31,27 +31,47 @@ </file> If more partitions are going to be used (like you want to have separate /boot or /home) then these need to be mounted now, too. ===== Network configuration ===== - ''RescueCd'' should configure (using DHCP) our network automatically during a boot process. If DHCP is not present, We need to do it manually. Let's assume We want to set IP to 192.168.0.2. **/etc/sysconfig/interfaces/ifcfg-eth0** should looks like: + + RescueCD and installed PLD system will use the same way of configuring network. + + By default both try to use DHCP to automatically configure network interface during a boot process. + If that works for you you don't need to do anything. + + If manual configuration is required then configure networking using files below. + + ==== eth0 interface configuration: /etc/sysconfig/interfaces/ifcfg-eth0 ==== + + Assume you want 192.168.0.2 with /24 network (CIRD notation is preferred) <file>DEVICE=eth0 - IPADDR=192.168.0.2 + IPADDR=192.168.0.2/24 ONBOOT=yes BOOTPROTO=none </file> - In file **/etc/sysconfig/static-routes** We added route to gateway (ex.: 10.0.0.254): - <file>eth0 default via 10.0.0.254 - </file> - In file **/etc/resolv.conf** we add at least one adress of DNS server: + ==== Default gateway and default gateway interface configuration: /etc/sysconfig/network ==== - <file>nameserver 193.192.160.243 - </file> - In the end We need to reload network configuration: + enable networking, ipv4 networking, set default gateway and interface which should be used to reach geteway: - <file># service network restart - </file> + <file> + NETWORKING=yes + IPV4_NETWORKING=yes + GATEWAY=192.168.0.254 + GATEWAYDEV=eth0 + <file> + + ==== DNS resolver IP addresses configuration: /etc/resolv.conf ==== + + Add default nameservers: + + <file>nameserver 1.1.1.1 + nameserver 8.8.8.8</file> + + === Reload network === + + <file># service network restart</file> ===== Poldek's configuration ===== In file **/etc/poldek/repos.d/pld.conf** We need to set **_arch = ** to chosen architecture ex.
Diff URL: https://www.pld-linux.org/docs/man/installing_pld_linux_based_on_rescue_cd?do=diff&r1=1548094749&r2=1548095458 -- This mail was generated by DokuWiki at https://www.pld-linux.org/ _______________________________________________ pld-cvs-commit mailing list [email protected] http://lists.pld-linux.org/mailman/listinfo/pld-cvs-commit
