I could not get the wireless working yet. :-(
$/sbin/ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:19:7D:BD:72:B5
inet addr:192.168.10.51 Bcast:192.168.10.255 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:19 Memory:d0200000-d0204000
$/sbin/iwconfig wlan0
wlan0 IEEE 802.11g ESSID:off/any Nickname:"penguin.xxxxxxxxx.xxx"
Mode:Ad-Hoc Frequency:2.462 GHz Cell: Not-Associated
Bit Rate=54 Mb/s Tx-Power:32 dBm
RTS thr=2347 B Fragment thr=2346 B
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Also for wired eth0 interface I get in "dmesg"
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
But for wireless wlan0 interface I do **not** get such line which
obviously means a fauilure :-(
I do get a follwoing line in there
ADDRCONF(NETDEV_UP): wlan0: link is not ready
despite my being able to ping to wlan0 ip address... but not to any
other external IP.
--
--
______________________________________________________________________
Pune GNU/Linux Users Group Mailing List: ([email protected])
List Information: http://plug.org.in/cgi-bin/mailman/listinfo/plug-mail
Send 'help' to [EMAIL PROTECTED] for mailing instructions.
