> > > >> I set a password in the Administration tab. Is that where I set the > >> WPA password? > > >That's the password for the management interface for the Linksys. In > >the management pages, there should be a Wireless tab, and a Wireless > >Security sub-tab. WEP bad, WPA good. > > On the Setup page there is a dropdown at the very top, set to Automatic > Configuration - DHCP by default. (DHCP Server down below is set to > Disabled.) The other options in the dropdown are Static IP, PPoE, PPTP > and HeartBeat. > >
None of these apply to your situation. > On the Wireless tab there is a dropdown for Wireless Mode, where the > default is AP, and the other options are Client and Adhoc. It is set to > AP. Below is a dropdown for Wireless Network Mode, set to Mixed. The > other options are disabled, B only, G only, and Afterburner. Then there > is Wireless Network Name (SSID), where I entered JJJ. The next dropdown > is for frequencies, and I left it at the default 6-2.437 GHz. Wireless > SSID Broadcast is set to Enable. > > AP is good, Mixed is good, SSID is good, defaults are good. > There is a Security tab, but it applies only to the firewall, which is > enabled. > > There is an Access Restrictions tab, which appears to be for allowing > only PCs with certain addresses, and also for restricting the time of > day when access is permitted. > > The next tab is Administration which starts at the top with the router > password. Then it has: > > Are you sure there aren't sub-tabs you're missing? can you put it on the Wireless tab and send me a screenshot? -wes _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
