>>>>> "Russell" == Russell Senior <[email protected]> writes:
>>>>> "VY" == VY <[email protected]> writes: VY> Hello All: I am looking for a mechanism from Linux to configure a VY> device that's a small ethernet server: VY> https://www.lantronix.com/wp-content/uploads/pdf/XPort-AR_CR.pdf VY> The initial steps involve configuring its BAUD rate, IP address VY> etc.. On Windows, per their instructions, folks are asked to use VY> things like telnet and hyperterminal, or other serial communication VY> tools. VY> On Linux, I have configured serial ports before, using things like VY> minicom. But those devices would show up as /dev/TTY***. In this VY> device, it is showing up in an ethernet port. VY> what tools can I use to configure this device in such scenario under VY> Linux? I know exactly which ethernet port it is connected to (e.g. VY> eth1) VY> thanks in advanced for any tip. Russell> I looked at the PDF and I still can't tell what it is. From Russell> what I could tell, you can connect over serial *or* telnet *or* Russell> ssh. So, if you are connected over ethernet, then you should Russell> use ssh or telnet (in that order). Have you looked at this? https://www.lantronix.com/wp-content/uploads/pdf/XPort-AR_QS.pdf -- Russell Senior, President [email protected] _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
