thanks, will give it a read
On Fri, Mar 17, 2017 at 5:19 PM, Russell Senior <[email protected]> wrote: > >>>>> "Russell" == Russell Senior <[email protected]> writes: > > >>>>> "VY" == VY <[email protected]> writes: > VY> Hello All: I am looking for a mechanism from Linux to configure a > VY> device that's a small ethernet server: > > VY> https://www.lantronix.com/wp-content/uploads/pdf/XPort-AR_CR.pdf > > VY> The initial steps involve configuring its BAUD rate, IP address > VY> etc.. On Windows, per their instructions, folks are asked to use > VY> things like telnet and hyperterminal, or other serial communication > VY> tools. > > VY> On Linux, I have configured serial ports before, using things like > VY> minicom. But those devices would show up as /dev/TTY***. In this > VY> device, it is showing up in an ethernet port. > > VY> what tools can I use to configure this device in such scenario under > VY> Linux? I know exactly which ethernet port it is connected to (e.g. > VY> eth1) > > VY> thanks in advanced for any tip. > > Russell> I looked at the PDF and I still can't tell what it is. From > Russell> what I could tell, you can connect over serial *or* telnet *or* > Russell> ssh. So, if you are connected over ethernet, then you should > Russell> use ssh or telnet (in that order). > > Have you looked at this? > > https://www.lantronix.com/wp-content/uploads/pdf/XPort-AR_QS.pdf > > > -- > Russell Senior, President > [email protected] > _______________________________________________ > PLUG mailing list > [email protected] > http://lists.pdxlinux.org/mailman/listinfo/plug > _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
