Folks, I have a radio that uses a USB link to an STMicro device. It shows up on my laptop as an SDMicroSD Flash. I need a program that I run in Wine to see it but cannot figure out how to make it visible to the program.
Here is the trace from a console capture: Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.086367] usb 1-1.1: new full-speed USB device number 8 using ehci-pci Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181567] usb 1-1.1: New USB device found, idVendor=0483, idProduct=5720 Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181577] usb 1-1.1: New USB device strings: Mfr=1, Product=2, SerialNumber=3 Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181583] usb 1-1.1: Product: Mass Storage in FS Mode Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181588] usb 1-1.1: Manufacturer: STMicroelectronics Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181592] usb 1-1.1: SerialNumber: 00000000001B Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.184059] usb-storage 1-1.1:1.0: USB Mass Storage device detected Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.184232] scsi host9: usb-storage 1-1.1:1.0 Jun 9 23:18:49 kp4djt-t420 mtp-probe: checking bus 1, device 8: "/sys/devices/pci0000:00/0000:00:1a.0/usb1/1-1/1-1.1" Jun 9 23:18:49 kp4djt-t420 mtp-probe: bus: 1, device: 8 was not an MTP device Jun 9 23:18:50 kp4djt-t420 kernel: [ 1136.184189] scsi 9:0:0:0: Direct-Access STM microSD Flash 1.00 PQ: 0 ANSI: 2 Jun 9 23:18:50 kp4djt-t420 kernel: [ 1136.185219] sd 9:0:0:0: Attached scsi generic sg2 type 0 Jun 9 23:18:50 kp4djt-t420 kernel: [ 1136.191102] sd 9:0:0:0: [sdb] Attached SCSI removable disk Any idea of how to make it visible in wine so I can load a code plug into the radio? -- Chuck Hast -- KP4DJT -- I can do all things through Christ which strengtheneth me. Ph 4:13 KJV Todo lo puedo en Cristo que me fortalece. Fil 4:13 RVR1960 _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
