Ken, The first thing I did was look in /dev to see if it was there but no joy. I see the device appear on my desktop as a ST MicroSD Flash, but I cannot find where to setup a link to the thing.
On Sun, Jun 10, 2018 at 11:02 AM, Ken Stephens <[email protected]> wrote: > Chuck, > > You need to add a link to it in ~/.wine/dosdevices > > Ken > > On Sat, Jun 9, 2018 at 9:20 PM Chuck Hast <[email protected]> wrote: > > > Folks, I have a radio that uses a USB link to an STMicro device. It shows > > up on my laptop as an SDMicroSD Flash. I need a program that I run in > > Wine to see it but cannot figure out how to make it visible to the > program. > > > > Here is the trace from a console capture: > > Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.086367] usb 1-1.1: new > > full-speed USB device number 8 using ehci-pci > > Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181567] usb 1-1.1: New USB > > device found, idVendor=0483, idProduct=5720 > > Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181577] usb 1-1.1: New USB > > device strings: Mfr=1, Product=2, SerialNumber=3 > > Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181583] usb 1-1.1: Product: > Mass > > Storage in FS Mode > > Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181588] usb 1-1.1: > Manufacturer: > > STMicroelectronics > > Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.181592] usb 1-1.1: > SerialNumber: > > 00000000001B > > Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.184059] usb-storage 1-1.1:1.0: > > USB Mass Storage device detected > > Jun 9 23:18:49 kp4djt-t420 kernel: [ 1135.184232] scsi host9: > usb-storage > > 1-1.1:1.0 > > Jun 9 23:18:49 kp4djt-t420 mtp-probe: checking bus 1, device 8: > > "/sys/devices/pci0000:00/0000:00:1a.0/usb1/1-1/1-1.1" > > Jun 9 23:18:49 kp4djt-t420 mtp-probe: bus: 1, device: 8 was not an MTP > > device > > Jun 9 23:18:50 kp4djt-t420 kernel: [ 1136.184189] scsi 9:0:0:0: > > Direct-Access STM microSD Flash 1.00 PQ: 0 ANSI: 2 > > Jun 9 23:18:50 kp4djt-t420 kernel: [ 1136.185219] sd 9:0:0:0: Attached > > scsi generic sg2 type 0 > > Jun 9 23:18:50 kp4djt-t420 kernel: [ 1136.191102] sd 9:0:0:0: [sdb] > > Attached SCSI removable disk > > > > Any idea of how to make it visible in wine so I can load a code plug into > > the > > radio? > > > > > > -- > > > > Chuck Hast -- KP4DJT -- > > I can do all things through Christ which strengtheneth me. > > Ph 4:13 KJV > > Todo lo puedo en Cristo que me fortalece. > > Fil 4:13 RVR1960 > > _______________________________________________ > > PLUG mailing list > > [email protected] > > http://lists.pdxlinux.org/mailman/listinfo/plug > > > _______________________________________________ > PLUG mailing list > [email protected] > http://lists.pdxlinux.org/mailman/listinfo/plug > -- Chuck Hast -- KP4DJT -- I can do all things through Christ which strengtheneth me. Ph 4:13 KJV Todo lo puedo en Cristo que me fortalece. Fil 4:13 RVR1960 _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
