On 12/18/18 2:59 PM, Ben Koenig wrote:
Options will be greyed out if the VM is currently running.
Right. I forgot about that one.
First make sure the VM is shut down and closed, and then go into settings. A lot of options are disabled because you need to change them BEFORE you run the VM.
Did that. The Enable USB Controller check box is no longer grayed out. I changed the radio button from USB 1.1 to USB 2.0, but when the virtual machine is running, it still doesn't see any USB devices. I'm pretty sure this device doesn't need USB 2. I think it's been around since before USB 2. All it is is three switches, so there's no particular need for a higher speed interface. I had forgotten that I have Express Scribe, a piece of transcription software that runs on Win2K. I tried running it and setting up the foot pedal, but it doesn't see it either. (Not surprising.)
-- Regards, Dick Steffens _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
