itm wrote: > I have an issue where after I have used the plug-in with my Onkyo > TX-NR515 receiver it seems to set the volume to zero when I later switch > to a different input on the receiver. So having been listening to music > for an hour using the Bridge I switch to TV and there is no audio - I > have to manually turn up the volume > ???
When LMS takes control of a UPnP player through the bridge, it wants to control its volume as well, and that include a behavior where LMS sets the volume to 0 when it stops or pause a track. I've set 3 options to handle that in 'LMS volume changes' section. You can choose to 1- ignore all LMS volume commands and in that case ou have to use the Onkyo remote to control volume or 2- only apply volume commands when the player is playing a track (default) 3- send all commands transparently Normally, 2- should fit your needs and (I just checked) no set to 0 volume command is sent when you stop or power-off the player in LMS. But, the volume set on the Onkyo will remain whatever was the volume when you were listening to music, so if this volume is too low for the TV input, then you'll have to manually adjust it, or ignore any LMS command and handle volume only with your remote LMS 7.7.2 - 5 radio, 3 Boom, 4 Duet, 1 Touch, 1 SB2. Sonos 2xPLAY:1, PLAY:3, PLAY:5, Marantz NR1603, JBL OnBeat, XBMC, Foobar2000, XBoxOne (sort of) ------------------------------------------------------------------------ philippe_44's Profile: http://forums.slimdevices.com/member.php?userid=17261 View this thread: http://forums.slimdevices.com/showthread.php?t=102496 _______________________________________________ plugins mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/plugins
