Man in a van wrote: > Have you tried > > user: pi > password: raspberry > > > > Or put the card in a reader into a windows machine, the boot files used > to be accessible that way. > > Ronnie > > Edit; still are > > > Code: -------------------- > > # For more options and information see > # http://www.raspberrypi.org/documentation/configuration/config-txt.md > # Some settings may impact device functionality. See link above for details > > # uncomment if you get no picture on HDMI for a default "safe" mode > #hdmi_safe=1 > > # uncomment this if your display has a black border of unused pixels visible > # and your display can output without overscan > #disable_overscan=1 > > # uncomment the following to adjust overscan. Use positive numbers if console > # goes off screen, and negative if there is too much border > #overscan_left=16 > #overscan_right=16 > #overscan_top=16 > #overscan_bottom=16 > > # uncomment to force a console size. By default it will be display's size minus > # overscan. > #framebuffer_width=1280 > #framebuffer_height=720 > > # uncomment if hdmi display is not detected and composite is being output > #hdmi_force_hotplug=1 > > # uncomment to force a specific HDMI mode (this will force VGA) > #hdmi_group=1 > #hdmi_mode=1 > > # uncomment to force a HDMI mode rather than DVI. This can make audio work in > # DMT (computer monitor) modes > #hdmi_drive=2 > > # uncomment to increase signal to HDMI, if you have interference, blanking, or > # no display > #config_hdmi_boost=4 > > # uncomment for composite PAL > #sdtv_mode=2 > > #uncomment to overclock the arm. 700 MHz is the default. > #arm_freq=800 > > # Uncomment some or all of these to enable the optional hardware interfaces > #dtparam=i2c_arm=on > #dtparam=i2s=on > #dtparam=spi=on > > # Uncomment this to enable the lirc-rpi module > #dtoverlay=lirc-rpi > > # Additional overlays and parameters are documented /boot/overlays/README > > # Enable audio (loads snd_bcm2835) > dtparam=audio=on > gpu_mem=128 > dtoverlay=iqaudio-dacplus > -------------------- > >
Thanks Man in a van, got in with pi/raspberry, but added the code in Windows, easier for me :) kidstypike LMS on Raspberry Pi 2 model B/max2play/HiFiBerry DAC+ > AVI DM5 1 x SB3 - 1 x Boom - 1 x (Squeezebox) Radio - 2 x Touch - 2 x Raspberry Pi/max2play/HiFiBerry ------------------------------------------------------------------------ kidstypike's Profile: http://forums.slimdevices.com/member.php?userid=10436 View this thread: http://forums.slimdevices.com/showthread.php?t=101856 _______________________________________________ plugins mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/plugins
