flysurfer wrote:
> For the new Jessie based Image of Max2Play, I did not add the user root
> for a direct SSH connection. You always have to SSH in with user "pi"
> and PW "raspberry" like in the original Raspbian as @Man in a Van said.
> If you want to get superuser rights you can either enter any command
> with the prefix "sudo" or change to root with "su" and PW "max2play"
> once logged in.
>
> Anyway I will build a Bluetooth switch to the Raspberry Settings Addon
> to make it more comfortable to change this setting.
Thanks
I've added the line "dtoverlay=pi3-disable-bt" at the bottom of the
config file, but I'm not sure it's in the correct place, as the player
still hisses, crackles and pops no matter which card option I select.
Code:
--------------------
# For more options and information see
# http://www.raspberrypi.org/documentation/configuration/config-txt.md
# Some settings may impact device functionality. See link above for details
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1
# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16
# uncomment to force a console size. By default it will be display's size
minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720
# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1
# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2
# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4
# uncomment for composite PAL
#sdtv_mode=2
#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800
# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on
# Uncomment this to enable the lirc-rpi module
#dtoverlay=lirc-rpi
# Additional overlays and parameters are documented /boot/overlays/README
# Enable audio (loads snd_bcm2835)
dtparam=audio=on
gpu_mem=128
dtoverlay=hifiberry-digi
max_usb_current=1
dtoverlay=pi3-disable-bt
--------------------
kidstypike
LMS on Raspberry Pi 2 model B/max2play/HiFiBerry DAC+ > AVI DM5
1 x SB3 - 1 x Boom - 1 x (Squeezebox) Radio - 2 x Touch - 2 x Raspberry
Pi/max2play/HiFiBerry
------------------------------------------------------------------------
kidstypike's Profile: http://forums.slimdevices.com/member.php?userid=10436
View this thread: http://forums.slimdevices.com/showthread.php?t=101856
_______________________________________________
plugins mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/plugins
