I did figure something out (wow that's a change). 1. create some tables directly in Access and made releationships between a few. 2. try to sync and I get an error saying there was issues in the "from" clause then next dialog says my PLUm table are AFU. 3. I deleted the relationships and PLUM IDE found the tables with no issues.
On Mon, 07 Feb 2005 08:18:56 -0500, Jeff Fleitz <[EMAIL PROTECTED]> wrote: > Hi Tim, > > I will give it a shot a little later today. > > I am busy downloading installing CFMX7, which is officially shipping for > those who haven't heard yet. > > http://www.macromedia.com/software/coldfusion > > Jeff > > Tim Blankenship wrote: > > Tried again and same results. The included starter database works > > fine. Jeff can you create a empty Access 2k db and try it out. Thanks > > > > > > On Sun, 6 Feb 2005 19:04:35 -0600, Tim Blankenship <[EMAIL PROTECTED]> > > wrote: > > > >>Just to clarify the tables are created but the sample data does not > >>get populated, so basically I have the default tables made but are > >>empty. > >> > >> > >>On Sun, 6 Feb 2005 18:49:31 -0600, Tim Blankenship <[EMAIL PROTECTED]> > >>wrote: > >> > >>>No this is a empty db I created. I am going to try again and make sure > >>>it is not a problem on my side. > >>> > >>>On Sun, 06 Feb 2005 16:21:05 -0500, Jeff Fleitz <[EMAIL PROTECTED]> wrote: > >>> > >>>>I have never seen this one. I have had a couple instance where I reran a > >>>>setup over an existing product and it added the > >>>>Churvis records to the database. Are you using a copy of the > >>>>StarterDatabase supplied in the setup/Starterdatabase > >>>>sub-directory? > >>>> > >>>> > >>>>Tim Blankenship wrote: > >>>> > >>>>>Anyone else get this? > >>>>> > >>>>>I setup a test project using Access 2k > >>>>>After the wizard on the setup page is displays error saying the > >>>>>Churvis family wasnt added to the db and I should manually do so. > >>>>>I use the IDE after the fact to populate the db with the sample data > >>>>>(Churvis family) and get an error - An unhandled exceprion has occured > >>>>>in your appliation....blah, blah,blah.....Invalid Platform. I ignore > >>>>>the message and eventaully the application crashes. > >>>>> > >>>>>My platform > >>>>>OS - WinXP pro > >>>>>DB - Access 2k > >>>> > >>>>********************************************************************** > >>>>You can subscribe to and unsubscribe from lists, and you can change > >>>>your subscriptions between normal and digest modes here: > >>>> > >>>>http://www.productivityenhancement.com/support/DiscussionListsForm.cfm > >>>>********************************************************************** > >>>> > >>> > >>>-- > >>>Tim Blankenship > >>>[EMAIL PROTECTED] > >>> > >> > >>-- > >>Tim Blankenship > >>[EMAIL PROTECTED] > >> > > > > > > > > ********************************************************************** > You can subscribe to and unsubscribe from lists, and you can change > your subscriptions between normal and digest modes here: > > http://www.productivityenhancement.com/support/DiscussionListsForm.cfm > ********************************************************************** > -- Tim Blankenship [EMAIL PROTECTED] ********************************************************************** You can subscribe to and unsubscribe from lists, and you can change your subscriptions between normal and digest modes here: http://www.productivityenhancement.com/support/DiscussionListsForm.cfm **********************************************************************
