I use ucarp for vrrp (HA) and it's working like a charm, also I have to say that it is very easy of configure and powerful.
Regards 2013/3/20 Jonathan Galentine <[email protected]> > I just setup a pacemaker cluster recently and wrote about it, might save > you some time if you go that route. > > > http://techdenovo.blogspot.com/2013/03/clustering-with-drbd-pacemaker-centos.html > > > Jonathan Galentine > > Chief Technology Officer > 7900 Westpark Dr, Ste A50, McLean, VA 22102 > Office: (703) 891-0131 x304 | Fax: (703) 891-0129 > [email protected] | www.ntiva.com > > > -----Original Message----- > From: Joe Gooch [mailto:[email protected]] > Sent: Wednesday, March 20, 2013 9:45 AM > To: '[email protected]' > Subject: RE: [Pound Mailing List] Pound Failover > > I have two boxes, set ip_nonlocal_bind, each one runs pound all the time, > and corosync/pacemaker moves the ip between them. So pound is always > running but it only receives requests when the cluster makes the server > active. > > Joe > > > -----Original Message----- > > From: James Bensley [mailto:[email protected]] > > Sent: Tuesday, March 19, 2013 7:08 PM > > To: [email protected] > > Subject: [Pound Mailing List] Pound Failover > > > > Hi All, > > > > How are people achieving fail-over with Pound, in the event the server > > becomes unavailable? > > > > I am thinking of something like keepalived to use VRRP to fail-over to > > a second box if the first one fails (so they share the same public > > IP), > > > > OR > > > > IPVS, again to share the same public. > > > > However, I haven't had a chance to lab up either scenario yet. Are > > people using either of the scenarios, which do they prefer? Or if you > > are doing something else, what are you doing, how is it working out > > for you? > > > > I am primarily after active/passive fail-over, active/active is a > > luxury extra. > > > > Many thanks, > > James. > > > > -- > > To unsubscribe send an email with subject unsubscribe to > > [email protected]. > > Please contact [email protected] for questions. > > -- > To unsubscribe send an email with subject unsubscribe to [email protected]. > Please contact [email protected] for questions. > > -- > To unsubscribe send an email with subject unsubscribe to [email protected]. > Please contact [email protected] for questions. > -- Load balancer distribution - Open Source Project http://www.zenloadbalancer.com Distribution list (subscribe): [email protected]
