Hi all! I've got a 3400 that has bad AC connector flex on the motherboard... (grrr--should never happen, in my opinion)
I was looking for a new mobo (or kanga!) but it just isnt cost effective. Any tips on going about repair? Im not bad with a soldering iron---but not expert either. I assume a finer solder (so's not to overheat components) and such...but what will stop the problem from just happening again? I do recall seeing a post here many moons ago about hot melt *glue* on toshibas with this problem, to help stabilize the joint. Any ideas/thoughts/experience really appreciated! regards -jim justen st paul, mn -- PowerBooks is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Enter To Win A | -- Canon PowerShot Digital Cameras start at $299 | Free iBook! | Support Low End Mac <http://lowendmac.com/lists/support.html> PowerBooks list info: <http://lowendmac.com/lists/powerbooks.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/powerbooks%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
