Well, after doing some looking around on AppleFritters, I've decieded to
mod a 520c with a 540 mobo and NuPower 167mhz PPC upgrade on board..
The thing is, do I need a speial screw driver?
I also have a 1400cs that needs a mobo replacement.. The problem is it
looks like someone tried to drill one of the screws out underneath, but did
not suceed.. Any ideas on how to get the bottom seperated? The replacement
mobo is coming from Timco complete with bottom plastics and mounted.. So all
I have to do is swap them out. But I can't get the current one off! Any
suggestions?
I just installed a new RAM module in my PowerBook 520c about half an hour ago. The only screwdriver I needed was a Torx T-8, available at Sears and probably other hardware or electronics stores as well.
Luca
-- PowerBooks is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Enter To Win A | -- Canon PowerShot Digital Cameras start at $299 | Free iBook! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
PowerBooks list info: <http://lowendmac.com/lists/powerbooks.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/powerbooks%40mail.maclaunch.com/>
Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
