The upper portion of the hinge screws into plastic mounts in the lid housing. There realy is no "pretty" fix. However, what I did was to drill a hole all the way through the lid (the same diameter as the hole in the hinge). Then I bought screws of that diameter. The head is on the outside of the lid and the nut gets covered by the plastic strip holding the microphone. Not very pretty (once painted is difficult to locate but not quite "factory" condition). However, it realy beefs this up quite a bit...
The other problem is usually with the lower part of the hinge. It enters an aluminum housing. The screw can back out, causing hinge wobble. I tightened mine up and added a little locktite to keep it from backing out... -- _______________________________________________ NEW! Lycos Dating Search. The only place to search multiple dating sites at once. http://datingsearch.lycos.com -- PowerBooks is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Enter To Win A | -- Canon PowerShot Digital Cameras start at $299 | Free iBook! | Support Low End Mac <http://lowendmac.com/lists/support.html> PowerBooks list info: <http://lowendmac.com/lists/powerbooks.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[email protected]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/powerbooks%40mail.maclaunch.com/> iPod Accessories for Less at 1-800-iPOD.COM Fast Delivery, Low Price, Good Deal www.1800ipod.com
