Hi there I am running a powerlogix G3 upgraded PowerCenter with 4 GB SCSI HD (HFS+) and 128 +64 +64+64 MB RAM under OS 9.1.
I tried to install a SIIG USB card, and the result was that the video went black, boh on the ISMicro PCI video card and on the on-board video, despite pushing the mainboard reset (several times). Thing is, I can hear the HD boot up normally, and can close it down OK from the keyboard. But the screen persists in remaining balck. Last time I had anything like this (on an LP PowerCenter), it came down to RAM, and re-sinatlling /reconfiguring the RAM solved it, but not this time. Any ideas folks? All help is gratefully received... MTIA Mark Willan [EMAIL PROTECTED] - [EMAIL PROTECTED] ARS EX NIHILO LUMEN 3 place des Cines - 06560 Sophia Antipolis - France Tel +33 4 9296 0919 Fax +33 4 9296 9004 NOTICE: This email is confidential, may be legally privileged, and is for the intended recipient only. Access, disclosure, copying, distribution, or reliance on any of it by anyone else is prohibited and may be a criminal offence. Please delete if obtained in error and email confirmation to the sender. -- Power Computing is sponsored by <http://lowendmac.com/> and... 123Inkjets.com <http://lowendmac.com/ad/123inkjets.html> Support Low End Mac <http://lowendmac.com/lists/support.html> Power Computing list info: <http://lowendmac.com/power/list.html> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> List archive: <http://www.mail-archive.com/powercomputing%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
