Which slot did you put the USB into? Some USB cards do not work properly unless they are in slot 1. Most likely it is a faulty seated riser card. remove everything and reinstall it and make sure its in tight.
Greg >Hi there > >I am running a powerlogix G3 upgraded PowerCenter with 4 GB SCSI HD >(HFS+) and 128 +64 +64+64 MB RAM under OS 9.1. > >I tried to install a SIIG USB card, and the result was that the video >went black, boh on the ISMicro PCI video card and on the on-board >video, despite pushing the mainboard reset (several times). > >Thing is, I can hear the HD boot up normally, and can close it down OK >from the keyboard. > >But the screen persists in remaining balck. > >Last time I had anything like this (on an LP PowerCenter), it came down >to RAM, and re-sinatlling /reconfiguring the RAM solved it, but not >this time. > >Any ideas folks? > >All help is gratefully received... > >MTIA > >Mark Willan >[EMAIL PROTECTED] - [EMAIL PROTECTED] -- -- Power Computing is sponsored by <http://lowendmac.com/> and... 123Inkjets.com <http://lowendmac.com/ad/123inkjets.html> Support Low End Mac <http://lowendmac.com/lists/support.html> Power Computing list info: <http://lowendmac.com/power/list.html> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> List archive: <http://www.mail-archive.com/powercomputing%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
