Or:
]L=:,>(10$(?10 $26){(65+i.26){a.)(;"0)' '
G Q W J R C O S Q C
(, 0 4 10 18{(i.20),.>:i.20){L
G W C C
Linda
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Linda Alvord
Sent: Tuesday, December 04, 2012 3:10 AM
To: [email protected]
Subject: Re: [Jprogramming] Getting more than one value back from "From" or
alternative approach
If all those people hadn't been awake all night you might have enjoyed:
]L=:,>(10$(?10 $26){(65+i.26){a.)(;"0)'0'
B0W0R0L0G0J0Y0Q0K0C0
(, 0 4 10 18{ (i.20),.>:i.20){L
B0R0J0C0
Linda
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of PackRat
Sent: Tuesday, December 04, 2012 1:18 AM
To: [email protected]
Subject: Re: [Jprogramming] Getting more than one value back from "From" or
alternative approach
Thank you, Ric and especially Bob!
Bob Therriault wrote:
> Is there a reason that you would not be able to add the spaces at the
> end using iji # ?
>
> sqdata=. 'X@@.@..@....@.......@....'
> e=.5 5 $ e3 { sqdata
> 1j1#"1 e
My original version was along your lines (that is, no spaces until the
end) except that I couldn't figure out how to insert alternating spaces in
the final result. Thus, I had to insert spaces in sqdata to come anywhere
close to a solution (that is, where output looked similar to what I was
looking for).
I'm familiar with iji, but only with respect to displaying decimal data. I
had never seen your use previously--but that's how this relative newbie
learns J better and better. (And thanks for noticing that the solution
could involve more possible characters than only '.'
and '@'.)
Thanks again to both of you!
Harvey
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
